| Wah Control-Tilt the pedal back and forth.
Fuzz Control-Rotate the pedal left and right.
Bottom Panel:
Effects Order-Switches the order of the effects in the signal path to provide two distinct sounds. Experiment!
Fuzz Volume-Adjusts the volume level of the Fuzz effect so that you can
match the volume level of your guitar when Fuzz is turned off. Also try
setting it for a Fuzz effect volume boost!
Fender Classics Series Fuzz-Wah Pedal Specifications:
- Input Impedance: 1MOhm
- Nominal Input Level: 20dBV
- Output Impedance: Fuzz -> Wah = 1kOhm; Wah -> Fuzz = 50kOhm
- Nominal Output Level: 20dBV
- Power Requirements: 9VDC (center pin = negative); 10mA Minimum
Fender Classics Series Fuzz-Wah Pedal Features:
- Fuzz Switch-Turns the Fuzz effect on-off.
- Wah-Turns the Wah effect on-off.
- Input Jack-Plug your guitar (or other audio source) in here.
Un-plug the input plug from this jack to turn off the device and save
power (very important) when not in use.
- Output Jack-Connect to the input of your amplifier (or other audio device).
- 9V Battery-Open the battery compartment on the bottom of the unit by removing the thumb screw. Use alkaline batteries.
- DC Input Jack-Plug in a AC- 9V DC adaptor (Not Included, see specifications) into this jack to eliminate the need for batteries.
|
