Features sophisticated protection circuitry (from shorted, open, or mismatched loads, input and high frequency overloads), 5-way fault indicator, red LED on each channel that turns on when distortion becomes audible, green signal-present LED that flashes when the level is extremely low (indicating cabling problems), and detented level controls. Mode select switch for stereo or bridged; 3-speed fan; and choice of 1/4", XLR, and barrier strip jacks; all in a rugged steel chassis designed to handle serious road use.

Crown XLS 802D Power Amplifier Specifications:

• Sensitivity (volts RMS) for full rated power at 4 ohms: 1.25 V.
  
  Frequency Response (at 1 watt) 22 Hz to 20 kHz: +0 dB, 0.8dB
  
  Signal-to-Noise Ratio (20 Hz to 20 kHz)_A-weighted, below rated power: _>98 dB. _No weighting, below rated power: _>93 dB.
  
  Total Harmonic Distortion (THD): <0.5%.
  
  Intermodulation Distortion (IMD):_(60 Hz and 7 kHz at 4:1) from full rated output to 40 dB: < 0.3%.
  
  Damping Factor (8 ohm) 10 Hz to 400 Hz: >200.
  
  Crosstalk (below rated power)_at 1 kHz: 76 dB. at 20 kHz: 58 dB.
• Input Impedance (nominal): 20 kilohms balanced, 10 kilohms unbalanced.
• Load Impedance: Rated for 2 to 8 ohms per channel in Stereo, 4 to 8 ohms in Bridge Mono.
  
  AC Line Voltage and Frequency Configurations Available (±10%): 120 VAC 60 Hz, 100 VAC 50/60 Hz, 220 VAC 50 Hz, and 230-240 VAC
  
  29.0 lbs.

Crown XLS 802D Power Amplifier Features:

• Features sophisticated protection circuitry
• 5-way fault indicator
• Red peak clip LED on each channel
• Green signal-present LED that flashes when the level is extremely low
• Detented level controls
• Mode select switch for stereo or bridged
• 3-speed fan
• XLR inputs
• Touchproof binding post and Speakon© outputs
• All in a rugged steel chassis designed to handle serious road use
• 3-year no-fault warranty