Like it's original predecessor, the Clarus 2 S4 is a two channel integrated head unit ... this time with 600 watts @ 4-ohms and 300 watts @ 8-ohms plus built-in effects.

The Clarus 2 S4 features two combination inputs jacks with 48v phantom power to accomodate either a 1/4" instrument input or an XLR microphone plug, a filter system to control feedback and a DI system for patching into a PA board or recording console. Weight is under 5 Lbs.

But the real story isn't about numbers and features. It's about SOUND. And Acoustic Image has improved fidelity in the S4 series dropping the self-noise floor to nearly imperceptible while maintaining the SPL volume equivalent to the previous + series. This makes a noticeable difference and the sound is transparent even at very high SPLs.

Solid state amplification just doesn't get any better than this.

Features

Extended frequency range, high fidelity sound
Light weight (<4 lbs.), small size (10.2 x 8.2 x 3.5)
Unique, slanted front chassis
Capable of being mounted in our Coda, Corus or Ten2 speaker cabinets
Combo jack input (either 1/4" or XLR)
Phantom power on XLR input
Three-band EQ preamp section per channel
Input and master level controls
Effects loop with return level control per channel
Switchable low cut filter per channel
Phase reverse switch per channel
Balanced direct out with ground lift
Digital effects with 6 presets and level control
Mute switch and pre/post EQ for direct out
Switchable limiter for high volume situations
Stereo capable with external power amp (2 ch preamp)
Headphone output
600 W switch mode power amplifier
Switchable dual voltage operation (100-115V/220-240V)
Dual speaker outputs via Speakon connectors
Comes with padded case, Speakon to 1/4 inch adaptor